HOBBYWING XRotor Micro Flight Controller F4 G3

FEATURES

- Redesign every aspect

- STM32 F405 MCU allows the FC to run the PID looptime and gyro with higher frequency.

- Board load 12V BEC, the output current can reach 2A. It can supply power for graphic transmission, 12V LED lamp and other equipments.

- The SPI ICM-20602 which integrates accelerometer and gyro (with the running frequency can be set to 32KHz) is adopted.

- Onboard OSD microchip which supports the DMA mode allows users to adjust its parameters via the Betaflight software. (Note: the OSD is controlled by the F4 MCU.)

- The FC which supports Betaflight firmware & allows parameter adjustment via Betaflight software is more applicable to FPV race.

- F-card which can record and save more flight/black box data allows users to adjust thesetup of their aircraft easily.

- Compatible with various receivers like SBUS, SUMH, SUMD, SPEKTRUM1024/2048, XBUS, PPM and etc.

- LED strip signal output port allows users to adjust the color & flash mode of the LED strip via the FC.

- Volt/Amp monitoring port allows users to check the battery voltage (BAT port) and current (CRT port , extra current meter is needed).

- Buzzer output port allows users to connect external buzzer(s) to the FC for warning or informing the flight status of the aircraft.

- Micro USB port allows users to connect the FC to a PC to flash firmware and adjust parameters.

- Switch module of board load graphic transmission(VTX) can use remote contorl to

- Control switch of graphic transmission.

SPECIFICATION

- Model: Micro F4 Flight Controller F4 G3 + OSD

- SKU: 31003001

- Application: FPVs with 130-300mm FPVs Diagonal Wheelbase

- Firmware: OMNIBUSF4SD

- FC Programming: supported

- Programming: via Betaflight/Cleanflight-configurator and Others

- Compatible with (Modes): PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600, DShot1200, Proshot1000 and etc

- Compatible with (Transmitters): PPM, Spektrum, SBUS, SUMD, SUMH, XBUS, IBUS, JETIEXBUS, CRSF, SRXL, and etc.

- OSD: Buit-in

- Voltage Monitoring: Supported

- Current Monitoring: Supported

- External Buzzer: Supported

- LED Control: Supported

- USB Port: MicroUSB

- Timing: Supported

- Motor Rotation: Supported

- size/ weight: 36*36mm / 6g